The pipe bending head of the pipe bending machine can move horizontally along the guide rail, which is necessary for the pipe bending machine to adjust the pipe groove of the bending die to align with the center line of the machine tool after the bending die is replaced. This is more simple and convenient than adjusting the center line of the machine tool by adjusting the guide rail and tailstock on the bed. The core rod mainly plays the role of supporting the curved inner wall of the pipe to prevent deformation during the bending process. At present, if the mandrel is not used when the domestic pipe is bent on the machine, its quality is more difficult to guarantee. There are also many kinds of mandrels, such as cylindrical mandrels, universal single, double, triple, and four-ball mandrels, directional single and multi-ball mandrels, and so on. In addition, the position of the mandrel also has a certain degree of influence on the bending and forming of the pipe. In theory, its tangent should be flush with the tangent of the pipe bending die, but after a lot of practice, it is better to be 1~2mm in advance. Manual mode enters the manual only to do the screen, press the button beside the action description to perform various actions. The end of the operation action is determined by the time set at the beginning. When the time is up, it will be displayed as “in place” after the full-automatic mode pedaling starts to operate. During the working state, the machine will stop working if the pedal is operated again, and the machine needs to continue to work. Pedal again and press the stop button to stop working. A work flow needs to be completed once by pedaling, that is, once at the beginning of the work. After pedaling in semi-automatic mode, the operation will start. During the working state, the machine will stop when pedaling again. If the machine needs to work again, pedal again. Press the stop button to stop working. A process flow allows two pedaling operations, that is, once when the work starts and once when the pipe is taken. The machine starts to work after the trial-type foot pedal. During the working state, the machine stops working if the foot pedal is operated again. If you need to work again, you need to pedal again, and you can stop working by pressing the stop button. Test machine related instructions: The test machine is only suitable for the dry running condition of the machine, and cannot be used for operation and processing! Please be cautious! The test machine just omits all the pedal actions from the first one, other action processes and production processing In the same way, after the work starts, the machine will continue to cycle until the count value is equal to the number set at the beginning or the key is considered to be stopped.
Get The Best Quote For Your Products
