What Are The Safety Requirements And Usage Methods Of Hydraulic System Of Pipe Bending Machine

Pipe Bender Hydraulic system is very important for pipe bending machine, so what are the requirements for hydraulic system?

1, when designing the pipe bending machine system, the components should be located in the installation and disassembly, and can be safely adjusted and working;

2, all components in the system must be in accordance with the manufacturer’s regulations to operate;

3, Pipe bending machine system must have overpressure protection;

4, all components in the system must have a certificate.

What are the use methods of hydraulic pipe bender? 1, the first is to connect the power supply, in the Control Panel to open the key switch, and then press the pump to start, so you hear the oil pump rotation sound.

(The machine does not move at this time) 2, stroke adjustment, pipe bending machine use must pay attention to adjust the itinerary, in the bend before you must test. The gap between a plate thickness must be guaranteed when the mold on the pipe bending machine goes down to the bottom. Failure to do so will cause damage to the mold and machine.

The adjustment of the itinerary is also with electric quick adjustment and manual gastric tone. 3, bending groove selection, generally want to choose the plate thickness of 8 times times the width of the groove.

If the bending 4mm sheet, you need to select about 32 of the groove.

4, the rear retaining material adjustment generally has the electric rapid adjustment and the manual fine-tuning, the method with the shearing machine. 5, step down the foot switch to start bending, pipe bender and shearing machine is different, can be loosened at any time, loosen the foot pipe machine will stop, in the step to continue the downlink.