Installation method of hydraulic pipe bending machine

The installation method of the hydraulic pipe bending machine: (1) BENDING DIE installation: a. Take off the wheel mold fixing nut (FIG-7(1) in a counterclockwise direction. b. Put the wheel mold in, and then put the wheel Fixing the mold fixing nut (2) Clamping mold (CLAMP DIE) installation: a. Pull out the clamp mold to fix the centering shaft (FIG-7(2), b. Put the clamp mold in, and then insert the fixed mandrel. .Adjustment: a. Fix the clamping mold base (FIG-7(3)), then put the control panel in manual mode, press the clamping tube button (FIG-7(3), to the end of the clamping mold path. (At this time) There needs to be a gap between the wheel mold clamping molds, and the clamping mold base adjustment screw (FIG-7 (4) to adjust). b. Adjust the clamping mold base adjustment screw (FIG-7 (4) to make the clamping mold and the wheel mold completely close Close. c. Press the retract button (FIG-4(6) to retreat the clamping mold, and then turn the clamping mold adjustment screw (FIG-7(4)) clockwise about 1/2-1/4 turn. d , And then tighten the clamping mold base fixing nut (FIG-7(3)). (3) PRESSURE DIE installation: a. Remove the guide mold fixing screw (FIG-(8), and then the guide mold Put it in. b. Tighten the guide screw. Adjust: a. Loosen the guide mold base fixing nut (FIG-7(5), then put the control panel in manual mode, press the pinch button (FIG- 4(3) to the end of the guide mold’s path (at this time there must be a gap between the wheel mold and the guide mold, which can be adjusted with the guide mold adjustment screw (FIG-7(6)). b. Adjust the guide seat adjustment screw (FIG- 7(6) Make the guide mold and the wheel mold completely close c, press or unclamp the button (FIG-416), and then turn the guide mold adjustment screw (FIG-7 (6) clockwise about 1/2-1 /4 turns. d. Then tighten the guide mold base fixing screw (FIG-7(6)). (4) Mandrel installation: a. Put the mandrel into the pinning rod in a clockwise direction. b. Fix the mandrel fixing screw (FIG-7(8)). (Please note that the mandrel must match the bending direction of the elbow).