Band sawing machine operators must be trained and skilled in metal band sawing machine horizontal band saw operation skills, operations staff to ensure the focus, to wear tight protective clothing before operation, cuff button, coat tails can not open, it is forbidden to wear gloves, not near the start of the sawing machine, change clothes, or throughout the body, prevent the machine from ground injury.
Before starting the band saw machine, do all the preparatory work, first check whether the coolant is enough, whether the cooling nozzle is normal, whether the air compressor is normally opened.
Before the sawing machine, it should also check whether the aluminum chip on the aluminum filter is clean, clean the aluminum chip on the table of the sawing machine, and ensure that the table is clean.
Band saw table must be flat. Before sawing test run idle for 1-2 minutes, and check the sawing machine has no fault, lubricating oil road is normal.
Adjust the length positioning according to the size of the workpiece. The positioning device must be locked after adjustment.
When cutting pipe or sheet material, the tooth distance should not be less than the thickness of the material. When sawing, return the handle to a slow position and reduce the amount of feed.
After adjusting the positioning, when opening the saw knife, pay attention to the body part is not close to the saw knife entry and exit position, should move away. At the same time, do not look at the face in the direction of the saw knife to prevent the aluminum dust from scratching your eyes and face.
When SAWING ALUMINUM MATERIAL WITH Angle, ADJUST THE Angle PLATE FIRST, MEASURE THE Angle, AND LOCK THE Angle PLATE after MEETING THE requirements OF the drawing.
During the operation of the saw machine, if abnormal sound is found and the force of the saw machine is insufficient, the power supply of the saw machine should be turned off immediately, and the saw blade and other key parts should be checked to see if they are normal. If there is any abnormality, the power supply should be reported in time, and professional maintenance personnel should be informed to repair, maintain and maintain the equipment.
After the work is finished, cut off the power supply, put the operating handle back on the empty space, and do a good job of cleaning.
Fill lubricating oil and sufficient coolant as required. When running empty, check whether all parts are normal. When the machine is running, if any fault is found, stop the machine immediately and report to professional maintenance personnel for maintenance.
When cutting the saw machine, do not measure the size and use hands or tools close to the saw blade and saw seam.
The power must be cut off at the end of each day. Open the shield. Remove chips, wipe clean, do a good job of daily maintenance and cleaning the surrounding environment.
Get The Best Quote For Your Products
